Skip to main content

Passivhaus

Utilise the properties of our airtight OSB, SMARTPLY PROPASSIV, and our breathable MDF, MEDITE VENT, to build an airtight Passivhaus building and acheive world class energy efficiency.

Our technical sales team can help you find the right product

info@mdfosb.com +44 (0) 1322 424900

Products

Case Studies

PROPASSIV House

Passivhaus in Cork uses SMARTPLY PROPASSIV

The site was in a challenging position, the location was confined with additional restricted access,
Camden Mews

SMARTPLY PROPASSIV provides energy efficient solution to environmental engineer’s Passivhaus project

Nestled in the fashionable, switched-on London borough of Camden, high-performance Max Fordham House

SMARTPLY PROPASSIV is an OSB/3 panel which achieves category 1 racking resistance. MEDITE VENT was tested to EN 594 and also achieves Category 1 racking resistance, using standard timber frame fixings. For further information on this please contact your local Technical Sales Manager.

MEDITE VENT is manufactured using the same moisture resistant (and no added formaldehyde) resin technology as SMARTPLY MAX OSB/3 and SMARTPLY ULTIMA OSB/4. This makes it suitable for use in Service Class 2 (humid) conditions and suitable for use as external sheathing panel in timber frame structures. MEDITE VENT must be protected by a suitable breather membrane and maintained in Service Class 2 conditions in the finished building.

PROPASSIV can be used as the only racking panel, installed on the warm side of the insulation and therefore can be used as the only sheathing panel in a wall build-up.

In cold temperate climates in Europe MEDITE VENT should be installed on the external side of the wall build up to allow water vapour to escape to the outside and avoid condensation in the insulation and structure.

SMARTPLY PROPASSIV has a very high vapour diffusion factor (dry cup 750) (i.e. it fulfils the requirement of a vapour control layer) to prevent excessive moisture entering the building fabric. On the other hand, MEDITE VENT has a very low water vapour diffusion factor (wet cup 9.7) (i.e. it is very ‘breathable’) to facilitate fast drying of built-in moisture and reduce the risk of interstitial condensation in walls. For further information and test reports please contact your local Technical Sales Manager.

YES. The certified passive house wall systems are certified with SMARTPLY PROPASSIV and MEDITE VENT included. All other wall and roof elements are generic, with only the minimum thermal performance as a requirement.

Very! SMARTPLY PROPASSIV has been independently tested by Fraunhofer Institute of Building Physics and the Passive House Institute and is a Certified Passive House airtight component. Furthermore, our 2 wall systems - Type S (Solid timber studs) & Type I (I Joist studs) have been certified by Passive House Institute. Below are the links to the PHI certified components database, where you can find details of our certified product and systems:

https://database.passivehouse.com/en/components/details/airtightness_system/medite-smartply-smartply-propassiv-0953ab03

https://database.passivehouse.com/en/components/details/construction_system/medite-smartply-medite-smartply-propassiv-type-s-0902cs03

https://database.passivehouse.com/en/components/details/construction_system/medite-smartply-medite-smartply-propassiv-type-i-0903cs03